LANMASTER, 110 wiring block, 1-pair

LANMASTER, 110 wiring block, 1-pair for copper structured cabling systems. LANMASTER product information, specifications and part number details.
LAN-S110P1

LANMASTER, 110 wiring block, 1-pair. Product for LANMASTER copper structured cabling systems. Use in connectors applications according to the project design and product specifications.

Most frequently asked questions and answers

What is the LAN-S110P1 plug used for?

The single-pair plug for a 110 cross-connect is intended for making patch cords. It is installed on solid or stranded conductors of 24–26 AWG (American Wire Gauge) with a diameter of 0.40–0.51 mm. To prevent wrong connection the plug has safety lugs and an arrow on the top side.

LANMASTER, 110 wiring block, 1-pair LAN-S110P1
Appearance LAN-S110P1
How do I install the LAN-S110P1 plug on conductors?

The plug body consists of two halves joined by latches. The conductors are connected to the IDC (insulation displacement contact) contacts (insulation displacement contacts) on one half: it is enough to lay the conductors into the grooves of the other half according to the wiring diagram and squeeze the halves together until they click.

What should I do if the product LAN-S110P1 does not work or works unstably?

Check that the connectors are fully latched, the conductors are connected by the same scheme at both ends of the link and there is no open or short circuit. Check the link with a tester, redo the termination if necessary and make sure the category of all components is not lower than required.

Didn’t find an answer to your question?

Package dimensions and weight

Single item

Unit length × width × height (mm) Weight (kg) Volume (m3)
box 470 × 50 × 100 0.255 0.00235

Product Codes (1)

  • LANMASTER, 110 wiring block, 1-pair
Specifications are subject to change without notice. For the most current information, consult LANMASTER or an authorized LANMASTER partner/distributor.