TWT, coaxial cable, 1U, black, 305 m

TWT, coaxial cable, 1U, black, 305 m for copper structured cabling systems. LANMASTER product information, specifications and part number details.
TWT-RG11-CS96/3-OTR

TWT, coaxial cable, 1U, black, 305 m. Product for LANMASTER copper structured cabling systems. Use in coaxial cables applications according to the project design and product specifications.

Most frequently asked questions and answers

What is the TWT-RG11-CS96/3-OTR coaxial cable used for?

The RG11 75-ohm cable is used in satellite and cable TV networks. It is used for backbone lines; it is installed outdoors. The cable with a messenger wire is used for aerial crossings between buildings in TV distribution networks. The operating temperature range is from −40 to +70 °C.

TWT, coaxial cable, 1U, black, 305 m TWT-RG11-CS96/3-OTR
Appearance TWT-RG11-CS96/3-OTR
What does CCS mean in the designation of the TWT-RG11-CS96/3-OTR cable?

CCS (copper-clad steel) means that the centre conductor is made of steel wire with a copper coating. It is stronger than a copper conductor, but has a higher DC resistance and higher losses at low frequencies. This is sufficient for TV signals on short and medium runs; if the cable also powers active devices (for example, amplifiers or converters), take the voltage drop on long runs into account.

How does the TWT-RG11-CS96/3-OTR cable differ from the RG6 cable and which should I choose?

The RG11 cable is thicker, has a larger centre conductor and lower attenuation over long runs, so it is chosen for backbone lines. The RG6 cable is thinner and more convenient for in-building distribution to subscribers. Choose RG6 for short branches and RG11 for long backbones; select F connectors for the specific cable type.

How do I terminate the TWT-RG11-CS96/3-OTR coaxial cable with an F connector?

Strip the sheath and carefully fold back the braid without damaging the foil and the dielectric, leave the centre conductor at the required length and fit an F connector designed for this cable type. Make sure the braid does not touch the centre conductor: a short degrades the signal. For outdoor connections protect the connector from moisture with a sealing boot.

How do I install the TWT-RG11-CS96/3-OTR coaxial cable with a messenger wire?

The steel messenger wire, not the coaxial part, carries the suspension load. Fix the messenger wire to poles or anchors with tension clamps without clamping the cable part. Avoid kinks at the clamp exit and follow the designed spans and sag.

How do I install and store the TWT-RG11-CS96/3-OTR cable?

Unwind the cable without loops or kinks, observe the minimum bend radius and do not tighten cable ties so that the sheath is crushed. Do not run the cable close to power lines. Store the cable in a dry room and protect the ends from moisture. Use the version with a polyethylene sheath for outdoor routes.

Didn’t find an answer to your question?

Package dimensions and weight

Single item

Unit length × width × height (mm) Weight (kg) Volume (m3)
coil 450 × 370 × 450 28.7 0.074925

Product Codes (1)

Specifications are subject to change without notice. For the most current information, consult LANMASTER or an authorized LANMASTER partner/distributor.